skip to Main Content
Asset 4

Warning: Switch the device off and disconnect it from the power supply before carrying out any services or maintenance.

Asset 3

Warning: Do not, under any circumstances, look directly into the radiation of the flash-lamps. It can cause damage to eyes.

Asset 1

Warning: Extended periods of irradiation may cause the polymerization chamber to heat up. Therefore, it is recommended to wait a few seconds before opening the lid after the end of polymerization (the fan will continue to run).

Asset 1

Warning: The dust filter behind the display on the front of the device should always be kept clean. Otherwise, it can cause over-heating and contamination.

Was this article helpful?

×Close search
Back to top