skip to Main Content

How to Connect the Oxygen Concentrator?

The oxygen concentrator creates a flow of oxygen into the printer via an internal series of tubes to the domeless material tray. It is delivered preset to the correct pressure. Simply remove it from the box and plug it into a PPS (Power Protection System) or a surge protector.

For additional information on how to set up the oxygen concentrator, check the Setting up the Oxygen Concentrator page.

The concentrator should stay on during printer operation. It can be turned off when the printer is not in use.
When turning the concentrator back on, wait 30 minutes for the oxygen to prime.

Was this article helpful?

×Close search
Back to top